Neutral Link

Application on 1-Phase & 3-phase, 50 Hz multiple neutral earthed system

Product successfully added to the Quote List

Neutral link 100A was designed for continuous operation on a 3-phase, 415V, 50 Hz multiple neutral earthed system.Housing Made from weather and UV resistant, fire retardant insulating material. A hole/slot each at the top and bottom.Manufactured in 2 parts i.e., top cover and base molding. Sealing provided to seal the top cover to the base Base moldingTerminal Block Connector Design with a hole Internal Diameter = 9mm, at least 2 pinching screws/stud of 8mm(M8) per hole, with incoming and outgoing hole. Inner side of hole is with threaded.Pinching screw and terminal shall made of tin plated brass. Pinching screw and terminal shall be electro- tin plated in accordance to BS 1872. Filled sufficient quantity of electrical conductive oxide inhibiting compound.

TECHNICAL DATA

Full Product Specifications

Description – 100A Neutral link
Voltage – AC 250/415V 50Hz
Number of Screw – 4
Color – Black
Manufactured – Malaysia
Comply To – IEC60947-1:2007

Related Products

Suspension clamp PS 1500 is designed to suspend LV ABC with insulated neutral messenger of cross-section between 16 mm² and 71,5 mm². It is resistant to environmental and mechanical effects and UV radiation since it is made of material of high tensile strength and stable structure. Suspension clamp allowsturning angle of 30/60°. It is installed using no tools and does not contain parts which can fall off during installation.

The helically preformed grip is used to hold/pull/tension the galvanized steel stay wire in the installation of the 33/22/11 kV overhead line systems such as pole and tower.

Photo Electric Control Unit (PECU) is an electronic switch which is triggered at a specific light level. Based on thermal, electronic or microprocessor technology, photocells operate in a number of ways depending of the level of accuracy required.Dusk to dawn sensing – generally inaccurate light detection where the lamp switches ‘ON’ as night falls and switches ‘OFF’ shortly after sunrise.Light level detection – more accurate light detection where the photocell switches at pre-set light levels both at sunset and sunrise, typically 70/35, 55/28, 35/18 or 20/20 lux. Negative switching sets the lamp to ‘OFF’ at a lower level than ‘ON’, with positive switching acting in reverse.

MODEL : IPCH-01

Insulating Piercing Connector Holder, IPCH-01 made from Aluminum Alloy high grade Tool was tested according to NFC 033-020:2013 and can with stand torque up to 40kN.

Weight : 450 g.
Minimum clamping jaw: 40 mm
Maximum clamping opening: 70 mm

Neutral Link

Product successfully added to the Quote List

TECHNICAL DATA

Full Product Specifications

Related Products

lv Suspension Clamp

Pre-formed Grip

Photo Electric Control Unit

Insulated Piercing Connector (IPC) Holder

MODEL : IPCH-01